Using the Remote control unit
Using the remote control as a PC mouse
You can use the remote control as your PC mouse. Set the Mode (Projector/Computer) switch on the remote control to Computer and connect the projector's USB port to your PC counterpart with the accessory USB cable.
|
| Projector |
| |
IN | OUT |
|
|
|
OUT |
| IN | OUT |
|
UDIO | USB | SERIAL |
| IN |
|
| |||
|
|
|
| OUT |
RGB 2 IN | RGB OUT | REMOTE | WIRED | |
|
|
| > PC < | TBMU152 |
Accessory | PC equipped with |
USB cable | a USB port |
•When your PC is attached to the projector for the first time, the “new hardware wizard” will launch automatically. When USB cable connects for the first time between projector and PC, the following massage appear from PC. The reason that the driver not installed, therfore press “NEXT” button continuously and finally. Press “Finish”.
The following is in the case of Windows
Note
•If you click “Cancel”, the “new hardware wizard” launches each time your PC is connected to the projector.
Mode switch (Computer/Projector)
Mode switch is set to the Computer position.
Page button
button 
•Page button
: Functions as the Page Up button on your PC keyboard.
: Functions as the Page Down button on your PC keyboard.
• Arrow (
) button
Mode switch (Computer/Projector)
| These buttons functions as the cursor control buttons |
Click button | on your PC. |
| • |
| This button functions as the right button on your PC |
| mouse. |
| • Click button |
| This button functions as the left button on your PC |
Note | mouse. |
•The optional wireless receiver (Model
16
