Using laser pointer
The remote control contains a laser source that can appear as a colored spot on the screen which you can use as a pointer. The laser beam is activated while the “LASER” button is pressed and held.
Warning
DO NOT STARE INTO THE LASER BEAM OR AIM IT AT ANY
PERSON'S EYE. LASER RADIATION CAN CAUSE SERIOUS
Laser Transmitter Window INJURY TO THE HUMAN EYE.
Operation indication lamp
AVOID
CAUTION
LASER RADIATION
DO NOT STARE INTO BEAM
WAVE LENGHT:
MAXIMUM OUTPUT: 1mW
CLASS II LASER PRODUCT
PRODUCT COMPLIES WITH DHHS RULES 21 CFR SUBCHAPTER J IN EFFECT AS OF DATE OF MANUFACTURE.
MANUFACTURER: MANUFACTURED:
B
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
WAVE
RAYONNEMENT LASER
NE PAS REGARDER DANS LE FAISCEAU APPAREIL A LASER DE CLASSE2
NICHT IN DEN STRAHL BL ICKEN LASER KLSSE 2
RADIZIONI LASER
NON GUARDARE NEL RAGGIO LUCE APPARECCHIO LASER DI CLASSE2
MATSUSHITA ELECTRIC INDUSTRIAL CO.,LTD.
MODEL NO.:N2QAEA000003 | |
REMOTE CONTROL | For LCD Projector |
MADE IN CHINA | |
P U S H
AVOID
RADIATION IS EMITTED FROM THIS APERTURE.
CAUTION
LASER RADIATION
DO NOT STARE INTO BEAM
WAVE LENGHT:
MAXIMUM OUTPUT: 1mW
CLASS II LASER PRODUCT
PRODUCT COMPLIES WITH DHHS RULES 21 CFR SUBCHAPTER J IN EFFECT AS OF DATE OF MANUFACTURE.
MANUFACTURER: MANUFACTURED:
B
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
WAVE
RAYONNEMENT LASER
NE PAS REGARDER DANS LE FAISCEAU APPAREIL A LASER DE CLASSE2
NICHT IN DEN STRAHL BL ICKEN LASER KLSSE 2
RADIZIONI LASER
NON GUARDARE NEL RAGGIO LUCE APPARECCHIO LASER DI CLASSE2
MATSUSHITA ELECTRIC INDUSTRIAL CO.,LTD.
REMOTE CONTROL MADE IN CHINA
Laser Specifications:
Wavelength: 640 to 660 nm
Output power: 1 mW (Class II)
C A U T I O N | old battery with new one. | batteries other then the typespecified. | batteries are inserted property. | TQFB385 |
| not use | not use | sure the |
|
| 1.Do | 2.Do | 3.Be |
|
Caution
•Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.
•This remote control unit cannot be repaired.
Setting projector IDs for remote control
When controlling multiple projectors individually or simultaneously with a single remote control, projector IDs must be set into the remote control as described in the following steps:
1. Press the “ID SET” button on remote control.
ID number “ALL” will be displayed on the OSD.
2. Press and hold the “ID SET” button for more than 2 seconds.
The ID number will change into “1”. The “ID SET” button will now toggle through ID numbers “2”, “3”, “ALL”, “1”, and so on each time it is subsequently pressed.
3. Select the ID number you wish and then press the “ENTER” button.
Note
•The projector ID number in the remote control is set to “ALL” by default. It is therefore not necessary to set a projector ID number when only one projector is used.
•The projector can be turned ON/OFF from the remote control only if the projector ID is set in the remote control. For more details on projector ID setting, see page 36.
15
