Panasonic PT-L6510U manual Starting to use, Powering Up the Projector, Powering Off the Projector

Starting to use

·

·

·

LEVELING Lever

on each side.

Powering Up the Projector

Remove the lens cover.

Plug one end of the accessory power cord into the projector's power receptacle, and the other end to a convenient wall outlet. (AC 100-120 V 50Hz/60 Hz)

Press the “ I ” marked side of the MAIN POWER switch.

The projector will enter standby mode, with the power status light lit in red.

Press the “POWER” button on the projector or “POWER” button on the remote control.

The power indicator on the projector will flash orange. After a shot period, the indicator will illuminate green.

Making Initial Adjustment /

Setting input port

Roughly adjust the focus with the “FOCUS (+/-)” buttons on the rear control panel or with focus ring on the projection lens.

Choose the projection scheme (page 34). Select the input port with the “RGB” or “VIDEO” button. --- [Projector or remote control]

RGB RGB1(YPBPR1)RGB2(YPBPR2)DVI

VIDEO S-VIDEO VIDEO

Adjust volume level with the “VOLUME (+/-)” buttons. --- [Remote control]

For volume level control on the projector, see page 27. If your audio equipment is connected to the AUDIO OUT jack, the VOLUME control adjusts the line output level.

Adjust the projector's tilt angle (page 24).

Adjust the vertical position of the picture (page 24) Press the “AUTO SETUP” button --- [Projector or remote control]

Fit the picture size to the screen size--- [Projector]

Fit the picture size to the screen size with the “ZOOM (+/-)” buttons on the projector's rear control panel.

Repeat steps through until the picture completely fits within the screen bounds.

Adjust focus again with the “FOCUS (+/-)” buttons on the rear control panel or with the focus ring on the projection lens.

Adjust the “ZOOM (+/-)” buttons again until the picture completely fits within the screen bounds.

Powering Off the Projector

1.Press and hold the “POWER” button for more than 0.5 seconds or quickly double-press the button. The projection lamp will turn off, with the power status light turned to orange.

2.Wait until the power status light turns to red (i.e., until the cooling fan stops). While the cooling fan is still running, never switch the MAIN POWER switch OFF, unplug the projector from the outlet, or open the main circuit breaker.

3.Press the “O” marked side of the MAIN POWER switch to remove all power from the projector.

Note

•If the projector is re-powered while the projection lamps are cooling down after the last power off, the lamps will remain off for a short time before they automatically turn on again (Power Status light flashing in orange).

•The projector consumes approx. 9 Watts of power in Standby mode after the cooling fan stops (Power Status light lit in red).

•If you inadvertently shut off the Main Power switch, the projection lamp may remain off for some time on re-powering the projector. The lamp will automatically turn on after a period of time (Power Status light lit in green).

23