How to use ADVANCED MENU (continued)
2.Press ENTER.
•The “CLAMP POSITION” screen will be displayed.
CLAMP POSITION
POSITION | 1 |
|
|
|
|
ADJUST
3.Press ◄► to adjust.
•The value changes from 0 to 255.
•The optimal value for the clamp position adjustment
If dark areas are crushed:
The optimal value is the point where the dark area is best improved.
If the dark areas are displayed in green:
The optimal value is the point where the green areas become black and the crushing effect is rectified.
Note
•The clamp position can be adjusted only when the RGB signal input is applied with RGB1 and RGB2 IN.
Edge blending adjustment
This projector has the function to hide the seams for
1. Press ▲▼ to select “EDGE BLENDING”.
| CLAMP POSITION |
|
|
| EDGE BLENDING | OFF |
|
| FRAME DELAY | DEFAULT |
|
|
|
|
|
2.Press ◄► to switch “EDGE BLENDING”.
•The setting will change as follows each time ◄► is pressed.
OFF | ON | USER |
•OFF:
When the
•ON:
When the tilting inside the unit is to be used for the tilting of the edge blending area.
•USER:
When a specific tilting is to be used for the tilting of the edge blending area. (Separate software is required to establish these settings. Consult your dealer.)
3.Press ENTER.
•The “EDGE BLENDING” screen will be displayed.
EDGE BLENDING
UPPER | ON |
|
START | 0 |
|
|
|
|
64 – ENGLISH
4.Press ▲▼ to specify the area to be adjusted.
•To joint the top: set “UPPER” to “ON”.
•To joint the bottom: set “LOWER” to “ON”.
•To joint the left: set “LEFT” to “ON”.
•To joint the right: set “RIGHT” to “ON”.
5.Press ◄► to toggle “ON” and “OFF”.
6.Press ◄► to adjust the compensation width and start position.
To display the adjustment marker
7. Press ▲▼ to select “MARKER”.
| RIGHT | OFF |
|
| MARKER | OFF |
|
| BRIGHT ADJUST |
|
|
8.Press ◄► to select “ON”.
•A marker for adjusting the picture position appears. The optimal point is the position where the red line of one frame overlaps the green line of the other frame.
The correction widths of the jointed frames must be the same value all the time. The optimal joint cannot be achieved if the jointed frames have different correction widths.
The optimal point is where
these lines overlap.
Green line
Red line
9. Press ▲▼ to select “BRIGHT ADJUST”.
| RIGHT | OFF |
|
| MARKER | OFF |
|
| BRIGHT ADJUST |
|
|
