Panasonic TQBJ 0268-5 operating instructions AUX DVI in Only when ET-MD77DV is installed

Display Option settings (continued)

AUX DVI IN (Only when the

ET-MD77DV is installed)

Change this setting if video does not display normally when the ET-MD77DV and an external device are connected via DVI-D.

1. Press ▲▼ to select “AUX DVI IN”.

DVI-D IN

AUX DVI IN

AUX SDI IN

2.Press ENTER.

• The “AUX DVI IN” screen will be displayed.

AUX DVI IN

AUX	DVI	EDID	EDID1
AUX	DVI	SIGNAL LEVEL	0-255:PC

3.Press ◄► to switch “AUX DVI EDID”.

•The setting will change as follows each time

◄► is pressed.

EDID1 EDID2(PC)

•EDID1 (Input signal formats supported) : Mainly select this when an external device (DVD player, etc.) for outputting video signals of a moving image system is connected to AUX DVI IN.

•EDID2 (Input signal formats supported) : Mainly use this when an external device (PC, etc.) for outputting video signals of a still image system is connected to AUX DVI IN.

4.Press ◄► to switch “AUX DVI SIGNAL LEVEL”.

•The setting will change as follows each time ◄► is pressed.

0-255:PC 16-235

•0-255:PC :

Select this when, for example, an external device (PC, etc.) is connected via the DVI terminal output.

•16-235 :

Select this when, for example, an external device (DVD player, etc.) is connected via the HDMI terminal output using a conversion cable.

Note

•The optimal setting differs depending on the output setting of the connected external device. Refer to the instruction manual of the external device.

•If the setting is changed, the data for plug and play changes. For the plug and play compatible resolutions, check the compatible signal list (pp. 120-121).

AUX SDI IN

Set this in accordance with the input module (sold separately).

1. Press ▲▼ to select “AUX SDI IN”.

AUX DVI IN

AUX SDI IN

ON-SCREEN DISPLAY

2.Press ENTER.

• The “AUX SDI IN” screen will be displayed.

AUX SDI IN

SDI LINK	AUTO
BIT DEPTH(DUAL LINK)	AUTO
SDI SIGNAL LEVEL	64-940

3.Press ▲▼ to select the desired item, and press ◄► to change

the setting.

zSDI LINK

Select the single link signal type or dual link signal type. The setting will change as follows each time the button is pressed.

AUTO SINGLE LINK

DUAL LINK

•AUTO:

Selects the setting automatically.

•SINGLE LINK:

Fixes the setting to signal link signal.

•DUAL LINK:

Fixes the setting to dual link signal.

zBIT DEPTH (DUAL LINK)

Select the gradation for the signals to be input. This is only valid when dual link RGB input. The setting will change as follows each time the button is pressed.

AUTO 12-bit

10-bit

•AUTO:

Selects 12-bit or 10-bit automatically.

•12-bit:

Fixes the setting to 12-bit.

•10-bit:

Fixes the setting to 10-bit.

72 – ENGLISH