Paradyne 9788, 9720 manual

December 2002

9700-A2-GB20-20

6-12

This command results in ending the Administrator access level session and returning immediately to Operator level.

end

You can end the Administrator access level by entering:

This command results in ending the current Administrator access level session. Exit may need to be entered several times to reach Operator level and/or end the session.

exit

￿

￿For further details, refer to Chapter 5, Configuring the FrameSaver DSL Router, and Appendix C, Router CLI Commands, Codes, and Designations.

Once saved, the router responds with a prompt to enter a password for Administrator access. This command is in effect until no enable password [ password ] is entered and saved.

You can end the current Administrator access level by entering:

enable password

password

enable

The router’s defaults to no password required. To require a password to access the Administrator access level, enter:

￿

6. Security and Logins

Changing Access Levels

The Operator and Administrator have the same Login ID with different passwords for their access level. To determine the level of access for a session, refer to Access Levels (Command Modes) on page 6-11.

After accessing the router’s CLI:

You can access the Administrator access level by entering: