Paradyne 9788, 9720 manual Table C-10. Dhcp Relay Agent Commands, No ip dhcp-server ip-address

C. Router CLI Commands, Codes, and Designations

DHCP Relay Agent Commands

Dynamic Host Configuration Protocol (DHCP) relay agent commands

Table C-10. DHCP Relay Agent Commands

ip dhcp relay max-clients max-dhcp-clients

no ip dhcp relay max-clients [max-dhcp-clients]

Minimum Access Level: Administrator

Command Mode: config

Allows you to limit the number of DHCP clients supported. The no dhcp relay max-agentscommand resets the maximum number of DHCP clients supported to the default of 1.

Example: ip dhcp relay max-clients 1

max-dhcp-clients– Number of DHCP clients supported: 1–256.

[no] ip dhcp-server ip-address

Minimum Access Level: Administrator

Command Mode: config

Allows you to specify or remove the address of the DHCP server where DHCP requests received on the Ethernet interface are forwarded. When no server address is assigned, the DHCP Relay agent is effectively disabled.

NOTE: The DHCP Relay agent cannot be enabled if either the DHCP server or NAT are enabled.

ip-address– IP address of the DHCP server.

C-18 December 2002 9700-A2-GB20-20