Paradyne 9788, 9720 manual Device Messages 5 What It Indicates What To Do, COM Port usage field

7. Operation and Maintenance

Table 7-3. Device Messages (5 of 5)

Message	What It Indicates	What To Do
Resetting Device,	Yes was entered for Reset	No action is needed.
Please Wait ...	COM Port usage field of
	the System Paused menu.
Save Cancelled	Changes were made on the	No action is needed.
	Easy Install screen, but the
	Esc key was pressed or No
	was entered in response to
	the Save Changes?
	prompt.
Test Active	No higher priority health	Contact service provider if test
	and status messages exist,	initiated by the network.
	and a test is running.	Wait until the test ends and
		message clears.
		Cancel all tests from the Test
		screen. Path: Main Test .
		Stop the test from the same
		screen the test was started
		from.
User Interface Already	Two Telnet sessions are	Wait and try again.
in Use	accessactive whenthe menuan attempt-drivento	￿Contact one of the IP address
	user interface through the	users and request that they log
		off.	→
	COM port is made.
	IP addresses and logins of
	the users currently
	accessing the interface are
	displayed.
User Interface Idle	Previously active session is	Log on to the FrameSaver unit.
	ended, and access via the
	COM port is now available.
	Session has been ended	No action is needed.
	due to timeout.
Value Out of Range	CIR entered for the DLCI is	Enter a valid CIR (0–1536000).
	a number greater than the
	maximum allowed.
	Excess Burst Size entered	Enter a valid Excess Burst Size
	for the DLCI is a number	(0–1536000).
	greater than the maximum
	allowed.
	DLCI Number entered is	Enter a valid number (16–1007).
	less than 16 or greater
	than 1007.

7-12 December 2002 9700-A2-GB20-20