Paradyne 9720, 9788 manual Save exit

5. Configuring the FrameSaver DSL Router

Procedure

To set up NAT:

1.From the Main Menu screen, press Ctrl-a then Shift-r to access the router’s Command Line Interface. Enter the following commands:

en config t

ip nat inside source static 10.1.3.2 192.128.22.28 ip nat inside source static 10.1.3.3 192.128.22.29 ip nat inside source static 10.1.3.4 192.128.22.30 ip nat inside source static 10.1.3.5 192.128.22.31

2.Enable NAT on interfaces with the following commands (where x is the number configured for the sub-interface):

interface ethernet 0 ip nat inside interface serial 0.x ip nat outside

3.Save the configuration and exit the CLI:

save exit

9700-A2-GB20-20 December 2002 5-7