Chapter 1. Assembling the Station
3.Slide the metal rod into the hole in the Station’s corner support and through the support brace until the rod exits through the hole in the other corner support. You may have to reach under the support brace to guide the rod into the opposite hole.
4.Finish tightening the screws to secure the support brace.
5.Remove the metal rod.
6.Position the rear lip of the drop shelf over the support brace so the shelf rests in the extended position. (Figure 7.)
end cap
Drop
Shelf
Support
Brace
Metal
Rod
Figure 7
w
To avoid hitting your fingers, use
7.On a firm surface, using a piece of cardboard for a pad, stand the metal rod on one end. Hammer an end cap onto the metal rod. The end cap should lock firmly.
8.Slide a plastic washer onto the metal rod.
