Reverse, Clear Window | Pelco C3412M-D instruction

SPECTRA IV

LANGUAGE

<SYSTEM INFORMATION> <DISPLAY SETUP> <DOME SETTINGS>

ACK ALERT*

RESET CAMERA

CYCLE CAMERA POWER REBOOT SYSTEM

EXIT

DOME SETTINGS

<CAMERA>

<MOTION> <POWER UP> <LINE SYNC> <PRESETS> <PATTERNS> <ZONES>

<WINDOW BLANKING> <ALARMS>

<AUX>

<TITLE TEXT> <ALERT>* <CLEAR> <PASSWORD> <CLOCK> <EVENT>

BACK

EXIT

WINDOW BLANKING

STYLE

BLANK ALL ABOVE

BLANK ALL BELOW

<SET WINDOWS>

BACK

EXIT

SET WINDOWS

WINDOW NUMBER

<EDIT WINDOW LOCATION> <EDIT WINDOW ZOOM> <EDIT SCHEDULE>

ENABLE WINDOW

REVERSE

CLEAR WINDOW

BACK

EXIT

6.The blanked area can be programmed to turn on or off at a specified zoom point. To set the zoom point:

a.Use the joystick to position the cursor beside EDIT WINDOW ZOOM, and then press Iris Open.

b.Zoom in to the point where you want window blanking to turn on. Press Iris Open to set the zoom point.

Notes:

•Since the area is already blanked out, it may be difficult to determine when you want window blanking to turn on. Reverse the window before setting the zoom point. When finished reverse the window again to blank out the area.

•Increase the size of the window if any part of the blanked area is revealed during PTZ operations.

Window Blanking Disabled

Window Blanking Enabled

EDIT SCHEDULE

The Edit Schedule menu is a duplicate of the Edit Event menu (refer to Event on page 80) with the following exceptions. In the Edit Schedule menu, the event type cannot be changed. Also, the Holiday feature cannot be accessed from the Edit Schedule menu.

For instructions on changing the features in the Edit Schedule menu, refer to Edit Event on page 83.

REVERSE

A blanked out area can be reversed to make it visible and the areas on both sides of it not visible. The areas above and below the blanking area remain visible. Reversing the window a second time will return it to its original condition.

CLEAR WINDOW

All areas that have been set for window blanking are cleared.

* This setting applies only to Pressurized Spectra IV dome systems.

66	C3412M-D (12/08)

Image 66

Pelco C3412M-D manual Enable Window Reverse Clear Window Back Exit

Contents

Spectra IV and Spectra IV SE Series Page Contents Wide Dynamic Range Field Align Repeat Ack Action Activate Aux Current Reading Reset Alert Welcome SW2 Switch 1 AD-32 Preset System InstallationSwitch Settings SW2 Switch 2 CM9502 Setting SW2 Switch 3 Control System Compatibility SW2 Switches 4-5 Serial Port Settings Dome Drive Installation SW2 Switches 6-8 Baud Settings Table A. Switch Settings for SW1 P-Type Control Table B. Switch Settings for SW1 D-Type Control OFF Table B. Switch Settings for SW1 D-Type Control 100 106 141 176 211 246 Getting Started How to Operate Your Dome System Operation Accessing Main Menu Preset Quick Programming Guide CM9500 Endura Workstation VCD5000 16X LowLight Color Menu Tree Edit the Password Clock Event Dome SettingsLine Sync Presets AUX 18X LowLight Day/Night Menu Tree Edit the Password Clock Line Sync Presets PatternsAlarms AUX Title Text 22X EXview LowLight Color Menu Tree Alarms Alarm Settings Line Sync 23X LowLight Day/Night Menu Tree Edit Detection Areas Patterns 35X LowLight Day/Night Menu Tree Edit Detection Areas Spectra Language ACK Alert Reset CameraLanguage Exit Address SW2 1 32 PRESETS. OFF DIP Switch InformationDIP Switch Information System Information Display Setup Exit Display Setup Preset LabelRestore Factory Defaults Back Exit Title Text Save and Exit Cancel and Exit Help XXX.XX Camera Dome SettingsExit Dome Settings Camera Type of Lighting Advanced Settings Back Exit Zoom LimitBack Exit Camera Zoom Speed LOW Light Limit IR CUT Filter Applies only to 18X, 23X, and 35X models Advanced Camera Settings Shutter SpeedAGC Limit Auto Iris Auto White Balance Gain B GainBack Exit Auto Sharpness Auto White Balance Video Level Dome Settings ACK Alert Reset CameraBacklight Compensation BLC Auto Iris Level Auto Iris Peak Sensor Scan Mode Field Align Electronic Image Stabilization Image Enhancement LOW LUX Noise Reduction Wide Dynamic Range Applies only to 23X and 35X models Auto Flip Proportional PAN Exit Dome Settings Camera Motion Power UP Park TimeBack Exit Motion Preset Freeze Frame Scan Speed Limit Stops Azimuth Zero Power UP Power UP ActionBack Exit Power UP Power UP Action Back Exit Line Sync Line Sync Phase Line Sync Presets Model Number of Stored Presets Back Exit Presets Preset Number Label for Preset Preset NumberAbcdefghij Cancel Klmnopqrst Uvwxyz Space C3412M-D 12/08 Edit Schedule Clear Preset Clear Camera Settings Back Exit Enable Motion DetectionPresets Preset Number Preset not Defined Edit Detection Areas Motion Detection Areas Activate AUX Command AUX TimeEdit Schedule Patterns Patterns ZonesBack Exit Patterns Zones Style Window BlankingBack Exit Window Blanking SET Windows Back Exit Enable Window Reverse Clear Window Back Exit ReverseClear Window Blank ALL ABOVE/BLANK ALL below Window Blank Tilt Angles Alarms C3412M-D 12/08 Default Normally open Back Exit AUX AUX 1 Mode Toggle Dwell Time Secs AUX 2 Mode AUXDwell Time Secs Edit Schedule Back Exit Title Text Back Exit Title TextEdit Title Text Alert Repeat Activate AUX Reset AlertACK Action Current Reading Clear Password Back Exit PasswordBack Exit Edit the Password Clock Month April DAY Clock Time Base Internal ClockHour END Date Month October DAY END Time Month April Week 1ST DAY Sunday Time Base Internal ClockMM/DD/YYYY END Date Month October Week Last DAY Sunday END Time Event Holiday Event TypeBack Exit Event Event Type Event Label Back Exit Reference Information Event Label Edit Event Label Back Exit Event Event Type Event Label Edit Event Label Event Type Preset Number Back ExitEdit Event Edit Event Event Label Event Active Event Time Clear Event List EventHoliday Edit Holiday Edit Holiday OccurrenceMonth January DAY Back Exit Clear Holiday List Holidays Scheduled Events Event Number Event Type Label Time Occurs Holiday Cycle Camera Power Reset, Cycle Power, RebootReset Camera Reboot System Software/Language File Upload Suggested Preventative Maintenance Specifications 16X Models 18X Models DD4CBW18 22X Models DD4C22 23X Models DD4CBW23 DD4CBW23-X 35X Models DD4CBW35 DD4CBW35-X Page Product Warranty and Return Information