4IMAGE QUALITY Slider Bar – Sets the quality of the recorded image. Image quality affects storage capacity and transmission rate. More bandwidth and storage capacity is required for high quality images. VHS image quality is equal to 43%.

5MOTION EXT. (Extended) DURATION Slider Bar – Sets recording time after motion is detected.

6SENSOR EXT. (Extended) DURATION Slider Bar – Sets recording time after a sensor is triggered.

7SWITCH SPEED Slider Bar – Sets the sequencing dwell time for cameras connected to the VGA and monitor output.

8WRITE INTERVAL Slider Bar – Determines how long images are stored in the buffer before written to the hard drive.

9SYSTEM MODE

Mode

Definition

Total FPS

How to Program

 

 

 

 

Simplex

Record or playback recordings. Cannot

160

Do not check the selection box labeled DUPLEX MODE

 

perform both tasks at the same time.

 

or the box labeled BACKUP.

 

 

 

 

Duplex

Record and playback recordings at the

60

Check the selection box labeled DUPLEX MODE

 

same time.

 

 

 

 

 

 

Backup

Record, playback and archive to a

40

Check the selection box labeled BACKUP.

 

backup device at the same time.

 

 

 

 

 

 

10USE MODEM Selection Box– Only available if modem software is installed.

11RECORDING SPEED Slider Bars -Control the recording rate of each camera separately by adjusting the control bar for each individual camera. The total available fps for all cameras varies per system mode setup (simplex, duplex, or backup).

12Average (A) Recording Rate Slider Bar – Equally distributes the total available recording rate to all enabled cameras. All enabled cameras are set to the same fps.

Example:

Total # of cameras

Total FPS

Average per camera

 

 

 

16

160

10

 

 

 

C665M-C (5/03)

17

Page 17
Image 17
Pelco DX7000 manual Mode Definition