Alignments

Index of this chapter:

1.General Alignment Conditions

2.Commercial Models SDAM Entry

3.Hardware Alignments

4.Software Alignments and Settings

Note: The Service Default Alignment Mode (SDAM) is described in the "Service Modes, Error Codes and Fault Finding" section. SDAM menu navigation is performed by using the MENU UP, MENU DOWN, MENU LEFT, and MENU RIGHT keys of the remote control transmitter.

General Alignment Conditions

Perform all electrical adjustments under the following conditions:

AC voltage and frequency: 110 V (± 10 %), 60 Hz (± 5 %).

Connect the television set to the AC power via an isolation transformer. Allow the television set to warm up for approximately20 minutes.

Measure the voltages and waveforms in relation to chassis ground (with the exception of the voltages on the primary side of the power supply). Never use heatsinks as ground.

Test probe: Ri > 10 MO; Ci < 2.5pF.

Use an isolated trimmer/screwdriver to perform the alignments.

Service Default Alignment Mode (SDAM) Entry for Commercial Models

Note: For commercial models, a master setup remote control is required in order to access the Service Default Alignment Mode (SDAM).

1.Use the master setup remote control to identify the television’s operational mode (either “consumer” or “commercial”). Place the master setup remote control in setup mode by pressing the TV SETUP key.

2.Press the RECALL key. Information similar to the following will be displayed.

Status Item

Status Data

Meaning

SYSTEM STATUS

 

Information title

(L011TV-US4PV)

 

MODE

COMMERCIAL/CONSUMER

Operational mode

CHANNEL

CHANNEL, INPUT

Currently tuned channel/input

DCM

OFF/ON

Data Comm. Module online/offline

CODES

209 222 1 33

Internal data for factory/service use

SIGNAL

TUNED/NOT TUNED

Valid signal present/absent

OP HRS

0031h

Number of hours set has operated (hex)

ERRORS

0 0 0 0 0

Internal data for factory/service use

Page 5
Image 5
Philips 27PS60S321 manual Alignments