English
,Always unplug the appliance after use and before you clean it.
,Do not use the appliance in a room with major temperature changes, as this may cause condensation inside the appliance.
,To prevent interference, place the appliance at least 2m away from electrical appliances that use airborne radio waves such as TVs, radios and
,The appliance is equipped with a safety device. If you have not placed the particle filter, the gas filter and the front panel properly, you cannot switch on the appliance.
,If the indoor air quality is poor (e.g. due to smoking or cooking or after renovation), we strongly advise you to open windows when you use the appliance to improve the air circulation.
,The appliance is only intended for household use under normal operating conditions.
,Do not use the appliance in wet surroundings or in surroundings with high ambient temperatures, such as the bathroom or kitchen.
,The appliance does not remove carbon monoxide (CO).
,AC4064 Noise level: Lc = 60,0 dB [A]
,AC4054 Noise level: Lc = 61,1 dB [A]
Electromagnetic fields (EMF)
This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled
properly and according to the instructions in this user manual, the appliance is safe to use based on
scientific evidence available today.
Before first use
Placing the gas filter
The appliance comes with all filters, except the gas filter, fitted inside.
Tip: Place the appliance against a wall for better stability when you remove or insert filters.
Note: Make sure you insert the filters in the correct position (with the arrow facing upwards).
Note:The appliance is equipped with a safety device. If you have not placed the particle filter, the gas filter and the front panel properly, you cannot switch on the appliance.
1Place your fingers in the recesses of the side panels. (Fig. 2)
2Gently pull the top part of the front panel off the appliance (1) and then lift the panel upwards to remove it (2) (Fig. 3).
3To remove the particle filter, grab the filter handles on both sides and gently slide the filter out of the appliance. (Fig. 4)
4Remove all packaging material from the gas filter and slide the filter into the appliance. (Fig. 5)
,You can only insert the gas filter after you have removed the particle filter.
5To insert the particle filter, slide it into the appliance (‘click’) (Fig. 6).
6To reattach the front panel, insert the bottom edge first (1) and then press the top part home (2) (Fig. 7).
Using the appliance
AC4064/AC4054
1Put the plug in the wall socket
,The standby light goes on (Fig. 8).