Philips AC4054, AC4064 manual Timer function, AC4062/AC4052, Cleaning and maintenance, English

English

2Press the function selection button one or more times to select the required function and setting (Fig. 9).

The corresponding light goes on and the standby light goes out.

,SmartAir Control: the built-in air sensor determines the ambient air quality and automatically selects the most appropriate speed. In the first few minutes after you select the SmartAir Control function, the air quality indicator flashes red to indicate that the air quality sensor is measuring the ambient air quality.After approximately 5 minutes, the air quality indicator lights up green if the air quality is good or lights up red if the air quality is poor (Fig. 10).

,BoostPower: the appliance operates at high speed for 30 minutes (BoostPower light is on) and then automatically switches to Smart Air Control (BoostPower light goes out

and SmartAir Control light goes on) (Fig. 11).

,Speed: the appliance operates at the speed you select.

-ê = low speed

-ë = medium speed

-í = high speed

3To stop the appliance from operating, press the function selection button until the standby light goes on (Fig. 12).

4Unplug the appliance.

Timer function

1Put the plug in the wall socket and select the required function and setting as described above.

2Press the timer button to set the operating time (1, 4 or 8 hours) (Fig. 13).

,The corresponding timer light goes on (Fig. 14).

,To deactivate the timer function, press the timer button and keep it pressed until the timer light goes out.

,When the set time has elapsed, the appliance automatically switches to standby mode.

Note: If you want to stop the air cleaning process before the set time has elapsed, press the function selection button until the standby light goes on.

AC4062/AC4052

1Put the plug in the wall socket

2Press the on/off button to switch on the appliance. (Fig. 15)

3Set the speed slide to the desired speed: low, medium or high (Fig. 16).

-ê = low speed

-ë = medium speed

-í = high speed

,The corresponding speed light goes on.

4Press the on/off button to switch off the appliance and unplug the appliance.

Cleaning and maintenance

Always unplug the appliance before you clean it.

Do not clean the body of the appliance, the particle filter and the gas filter with water or any other liquid or detergent.

Do not touch the corona field charger when you clean the appliance.