Adjusting loudness, Adjusting the equalizer curves

	Chapter
Audio adjustments	27

Vocal

Vocal is a curve in which the midrange, which is the human vocal range, is boosted.

Flat

Flat is a flat curve in which nothing is boosted.

Custom

Custom is an adjusted equalizer curve that you cre- ate. A separate custom curve can be created for each source.

1Display the “Audio Menu” screen.

=For details, refer to Displaying the

“Audio Menu” screen on the previous page.

2Turn MULTI-CONTROL to select

“Preset Equalizer”.

3Press MULTI-CONTROL left or right to select an equalizer curve.

Adjusting the equalizer curves

You can adjust the currently selected equalizer curve setting as desired. Adjustments can be made with a 3-band parametric equalizer.

!Band:

You can select the equalizer band.

!Frequency:

You can select which frequency to set as the center frequency.

!Level:

You can select the decibel (dB) level of the selected EQ.

!Q:

You can select the details of the curve char- acteristics. (The following figure shows the characteristic image.)

1Display the “Audio Menu” screen.

=For details, refer to Displaying the

“Audio Menu” screen on the previous page.

2Turn MULTI-CONTROL to select

“P.EQ Setting1”.

3Press MULTI-CONTROL left or right to select the equalizer band to adjust.

Each time MULTI-CONTROL is pressed left or right, level is selected in the following order: Low — Mid — High

4Press MULTI-CONTROL up or down to adjust the level of the equalizer band. Each time MULTI-CONTROL is pressed up or down, the level of the equalization band in- creases or decreases. “+6” to “-6” is displayed as the level is increased or decreased.

5Turn MULTI-CONTROL to select

“P.EQ Setting2”.

6Press MULTI-CONTROL left or right to select the desired frequency.

Press MULTI-CONTROL left or right until the desired frequency appears in the display. Low: 40 Hz — 80 Hz — 100 Hz — 160 Hz Mid: 200 Hz — 500 Hz — 1 kHz — 2 kHz High: 3 kHz — 8 kHz — 10 kHz — 12 kHz

7Press MULTI-CONTROL up or down to select the desired Q factor.

Press MULTI-CONTROL up or down until the

desired Q factor appears in the display. 2W — 1W — 1N — 2N