2 Select and set the method for switching the

07 speaker to be adjusted.

Use / to select, then press ENTER.

Auto – Switch the speaker to be adjusted automatically.

Manual – Switch the speaker to be adjusted manually.

3 Adjust the output level.

Use / to select, / to adjust.

 

Channel Level

 

BD PLAYER

L

0.0 dB

C

0.0 dB

R

0.0 dB

SR

0.0 dB

SBR

0.0 dB

SBL

0.0 dB

SL

0.0 dB

SW

0.0 dB

 

 

Note

You can also adjust while listening to the sound being played (page 40).

The volume of the test tones output from the subwoofer may seem lower than the tones output from the other channels. Adjust the subwoofer based on the sound during playback (page 40).

When Auto is selected, the speaker cannot be selected with /. In this case, test tones are not output from the subwoofer.

Setting the IP address

1Select and set Network IP Address Next

Screen.

Use / to select, then press ENTER.

2Set IP address.

Use /// to set the IP address of the player or DNS server, then press ENTER.

Network

BD PLAYER

IP Address

 

 

Auto Set IP Address

Off

IP Address

 

 

Subnet Mask

 

 

Default Gateway

 

 

Auto Set DNS Server Address

Off

 

DNS Server (Primary)

 

 

DNS Server (Secondary)

 

 

Auto Set IP Address

On – The player’s IP address is obtained automatically. Select this when using a broadband router or broadband modem that has a DHCP (Dynamic Host Configuration Protocol) server function. This player’s IP address will automatically be allocated from the DHCP server.

48

Off – The player’s IP address must be set manually. Use the number buttons (0 to 9) to input the IP address, subnet mask and default gateway.

Auto Set DNS Server Address

On – The DNS server’s IP address is obtained automatically.

Off – The DNS server’s IP address must be set manually. Use the number buttons (0 to 9) to input the DNS server’s IP address stipulated by your Internet service provider.

Note

When Auto Set IP Address is set to Off, Auto Set DNS Server Address is also set to Off.

For information on DHCP server function, refer to the network device’s operating instructions.

You may need to contact your Internet service

provider or network administrator when inputting the IP address manually.

Setting the proxy server

Only set the proxy server if so instructed by your Internet service provider.

1Select and set Network Proxy Server Next

Screen.

Use / to select, then press ENTER.

2Select and set Use or Not use at Proxy Server. Use / to change, then press .

Network

BD PLAYER

Proxy Server

 

 

Proxy Server

Use

Server Select Method

Server Name

 

Server Name

 

 

Port Number

 

 

Use – Select this when using a proxy server.

Not use – Select this when not using a proxy server. If you have selected Use, proceed to step 3.

3Select and set Server Select Method. Use / to change, then press .

IP Address – Input the IP address.

Server Name – Input the server name.

4Input IP Address or Server Name.

Use the number buttons (0 to 9) to input the number if you select IP address by step 3. Use / to move the cursor.

Use the number buttons (0 to 9) to input characters if you select Server Name by step 3.

The characters that can be input for the server name are listed on the table below. Pressing a button repeatedly cycles through the characters shown.

En

Page 48
Image 48
Pioneer BDP-V6000 operating instructions  Setting the IP address,  Setting the proxy server