Pioneer DVR-230-S manual Playing audio CDs and MP3s, Playing Video CDs

Getting started 04

Press to skip to previous/next chapter/title. (You can also use the front panel +/– but- tons to do this during playback.)

CM SKIP (Commercial skip). Each press skips for- ward progressively up to a maximum of

ten minutes.

				• Except VR mode: during playback, enter a
1	2	3
				chapter number then press ENTER to skip
4	5	6
				directly to that chapter within the currently
7	8	9	0	playing title.
				On some discs, you can also use the num-
			ENTER	ber buttons to select numbered items in
				the disc menu.

•VR mode only: during playback, enter a title number then press ENTER.

•All: Press CLEAR to clear a number entry and start again.

Press to display the ‘top’ menu or menu of TOP MENU MENU a DVD-Video disc (these are often the

same).

Use the cursor buttons to navigate DVD- Video disc menus; press ENTER to select

ENTER items.

RETURN Press to return to the previous level of a DVD-Video disc menu.

Playing audio CDs and MP3s

The table below shows the basic playback controls for audio CDs and MP3 files.

Press to start playback.

Press to pause playback; press again to restart playback.

Press to stop playback.

Audio CD only: Press to start scanning. Press again to increase the scanning speed. (There are two scan speeds; the current scan speed is shown on-screen.)

Press to skip to previous/next track (or folder for MP3 disc). (You can also use the front panel +/– buttons to do this during playback.)

1	2	3		During playback, enter a track (or folder)
				number then press ENTER to skip directly
4	5	6
				to that track.
7	8	9	0	Press CLEAR to clear a number entry and

start again.

ENTER

Note

•If you want to play a DTS audio CD, make sure the recorder is connected to a DTS-compatible amp/ receiver with a digital connection. Noise will be output through the analog outputs. Also make sure that STEREO is selected using the AUDIO button (see Switching audio channels on page 32).

•You can’t use scanning when playing MP3 files.

Playing Video CDs

The table below shows the basic playback controls for Video CDs.

Some discs feature Playback Control (PBC for short) menus. These discs show PBC in the display when you load them and display a menu on-screen from where you can select what to watch.

Press to start or restart playback.

Press to pause playback; press again to restart playback.

Press to stop playback.

You can resume playback from the same point by pressing . (Press again to cancel the resume function.)

•During playback, press to start scan- ning. Press repeatedly to increase the scanning speed.

•Press and hold while paused to start slow-motion playback. Press repeatedly to change the playback speed (forward direc- tion only).

•While paused, press to advance a single frame (forward direction only).

Press to skip to previous/next track. (You can also use the front panel +/– buttons to do this during playback.)

When a PBC menu is displayed, press to display the previous/next page.

CM SKIP (Commercial skip). Each press skips for- ward progressively up to a maximum of

ten minutes.

23

En