Pioneer DVR-920H operating instructions Erase Section Erase Sec, Enter

08Copying and back-up

Erase Section (Erase Sec)

Using this command you can delete a part of a Copy List title, ideal for cutting out the commercial breaks in a

recording made from the TV.1

1Select ‘Erase Sec’ from the Copy List menu options.

2 Use the (cursor left/right) buttons to select the title you want to erase a section from, then press

ENTER.

After selecting a title, a screen appears from which you can mark the start and end points of the section to erase.

Erase Sec

HDD	Title	2	16:00 Sun 11/08 Pr 5	LP
			Recording Time	0h32m55s
			2-1		0.06.52.17
			Play Pause
Erase Sec			A		B
			From		To

Back

5Select ‘Yes’ to confirm, or ‘No’ to cancel, then press ENTER.

In the thumbnail viewer you can see a few seconds of video either side of the marked section to see how the edit will look.

6Repeat steps 3 to 5 if you want to erase more sections from the same title.

7Select ‘Back’ (or press RETURN) to get back to the main Copy List screen.

3Use the playback controls to find the start of the section to erase, then (with ‘From’ highlighted) press

ENTER.

You can use all the usual playback controls, including

PLAY, PAUSE, scan ( ,	), and slow-motion
( , ).

The bar at the bottom of the screen shows the current play position in the title. After pressing ENTER, a marker appears under the bar to show the start of the section.

Play Pause

AB

From T 0.02.09.17

A

4In the same way, find the end of the section to erase, then (with ‘To’ highlighted) press ENTER. After pressing ENTER, another marker appears under the bar to show the end of the section, with the section itself marked in red.

Note

1When Frame Accurate is set to Off (see Frame Accurate on page 118), the ‘From’ time and length of the erased section may differ by up to 0.5 seconds from that set.

80

En