Error Codes in the UltraRes Control Software
Error Code | Meaning | Display Behavior and Solution |
|
|
|
DC Power Supply | One of the | The display will not start up if this |
Failure | the main board of the display has | occurs. |
| failed. | Solution: The main board needs to |
|
| be replaced. |
|
|
|
FPGA Initialization | One of the FPGAs on the main | There are two possible causes: one |
Failure | board did not start up correctly. | of the FPGAs has corrupt code or is |
|
| damaged. |
|
| Solution: First check the FPGA |
|
| status LEDs on the main board. If |
|
| one is not blinking, that FPGA |
|
| didn’t start up. The FPGA code may |
|
| need to be programmed again. |
|
| Solution: If reprogramming an |
|
| FPGA doesn’t work, it is likely the |
|
| FPGA is damaged. If this is the case, |
|
| the main board needs to be |
|
| replaced. |
|
|
|
Calibration | The main board could not | It is likely that the calibration |
EEPROM Failure | communicate with the calibration | EEPROM cable is disconnected. |
| EEPROM. | Solution: Connect the EEPROM |
|
| cable. |
|
|
|
Planar UltraRes User Manual | 143 |
