Installing an UltraRes Display on a Wall

bSingle point attachment: The angle between the top of the panel and the support lines should not be less than 45 degrees. This means that the attachment point must be at least 485 mm (19.1 in) above the top of the panel.

3Lift the panel into place.

4Detach the upper half of the lift block from the lower half by removing the two vertical screws. This leaves the bottom half attached to the panel but hidden.

Planar UltraRes User Manual

37

Page 37
Image 37
Planar 020-1229-03A user manual Installing an UltraRes Display on a Wall