Remote Monitoring Network Setup
Remote Monitoring Software Setup (Upgrading Network Firmware)
This page allows you to upload the latest UltraRes Remote Monitoring software. You can also reset all of your settings to the factory defaults, as well as choose the web page link that is associated with the Planar logo in the top right corner of the page.
1Click Choose File to locate the latest UltraRes software that you downloaded from Planar’s website.
Note: Make sure the software is downloaded to a local drive.
2Click Load Software to load the new software. This process can take a few minutes, depending on the speed of your network. It is very important that you do not interrupt the load process once it begins!
3If you want to reset ALL settings to the factory default, click Reset ALL to Factory Default. This includes network settings, date and time, etc., as well as display settings.
Caution: Using this option will reset all of your configurations and reboot the remote monitor. Because this includes network settings, be aware that the UltraRes Remote Monitoring software may not configure to the same network address after the system reboots.
4When you click Reset ALL to Factory Default, you receive the Confirm Factory Reset page. Click OK, Reset to Factory Defaults and Reboot if you are sure you want to reset ALL settings to the factory default.
5The top of each page shows the Planar logo, which is a link to http://www.planar.com. You can change this link to refer to any URL that you find useful by typing it into the Product ID Link box.
Planar UltraRes User Manual | 97 |
