MGC Manager User’s Guide
A-3
Bonding Failure Bonding failure Bonding negotiation
failed. For example, the
endpoint didn't reply.
(ISDN only)
Long delay between
channels The bonding channels
cannot be synchronized
by the MUX, because
the delay in data
transfer between the
channels is too long, or
downspeed is required
and the endpoint
supports
downspeeding, but the
MCU doesn't. (ISDN
only)
Internal error Internal error occurred.
(ISDN only)
No answer from remote
part Bonding failure due to
timeout. (ISDN only)
Error in dialing
additional channels H.221 bonding error.
The endpoint declared
less channels than the
MCU wanted, or an
error occurred when
attempting to open
additional channels.
(ISDN only)
Bad H243
Connection No established H243
connect Not currently used.
Full bitrate connection
failure The system can not
establish a connection
with the participant
using the maximum
possible line rate
capacity. (ISDN only)
Table A-1: Primary Disconnection Reasons (Continued)
Category Cause Message Description