Tsunami MP.11 Installation and Management
CONFIGURATION RESTORE
You can restore the configuration of the MP.11 by downloading a configuration file. The configuration file contains the configuration information of an MP.11.
To download a configuration file through the Web Interface:
1.Set up the TFTP server as described in “TFTP Server Setup” on page 64.
2.Access the MP.11 as described in “Web Interface Overview” on page 20.
3.Click: Commands Æ Download.
4.Fill in the following details:
Server IP Address <IP address TFTP server> File Name <configuration file name>
File Type Config
File Operation Download
5.Click OK to start the file transfer.
The MP.11 downloads the configuration file. The TFTP server program should show download activity after a few seconds. When the download is complete and the system rebooted, the configuration is restored.
CLI Configuration File Download
To download a configuration file:
1.Set up the TFTP server as described in “TFTP Server Setup” on page 64.
2.Access the MP.11 as described in “Command Line Interface” on page 21.
3.Enter the following command:
download <IP address TFTP server> <configuration file name> config
The MP.11 downloads the configuration file. The TFTP server program should show download activity after a few seconds. When the download is complete and the system rebooted, the configuration is restored.
Chapter 7. Procedures | 67 |
CPN 63708 | Issue Date: 02/05/2003 |
