4–Non-Interactive Commands
Command Summary
SN0054614-00 K 4-43
To set the link speed of selected target(s) attached to one adapter to the
designated speed, type the following command:
#scli -q (<hba instance> | <hba wwpn> | <all>) <target wwpn>
<speed>
Where:
-qos

(QoS Menu)

SANsurfer FC/CNA HBA CLI provides quality of service (QoS) for virtual ports on
8Gb adapters only. For a detailed explanation of the requirements and usage of
QoS, see “QoS Menu (Command Line Option -qos)” on page 3-101.
Use virtual port QoS as follows:
To show current QoS settings for all virtual ports on a physical adapter port,
enter the following command:
# scli -qos <hba instance>|<hba wwpn> info --vp <all>
[--spd|--per]
To show current QoS settings for a specific virtual port on a physical adapter
port, enter the following command:
# scli -qos <hba instance>|<hba wwpn> info --vp <vport wwpn>
To change QoS settings for specified virtual ports, enter the following
command:
# scli -qos <hba instance>|<hba wwpn> {--vp <vport wwpn> --pri
<priority>|--bwspd <speed>|--bwper <percent>| --lock <lock
value>|--enable <enable value>}
Where:
hba instance =Adapter number (use -g command to find)
hba wwpn =World wide port name of the adapter
all =Reports link speed for all targets on all adapters in the system
target wwpn =World wide port name of the target
speed =Link speed
hba instance =Adapter instance number for an adapter port
hba wwpn =World wide port name of an adapter port
all =All virtual ports under a physical adapter
--per =View virtual port QoS information by percentage
--spd =View virtual port QoS information by speed
vport wwpn =World wide port name of a virtual port