A – Log Messages Fatal Log Messages
S
978 iSCSI processor reboot failed.
1152 iSCSI processor NVRAM invalid (checksum error).
1203 iSCSI FLASH (NVRAM) command failed.
1204 iSCSI firmware loader invalid state.
1205 iSCSI failed to load firmware in time allotted.
FC Driver
The following fatal log messages are common to both Fibre Channel ports, 1 (FC1) and 2 (FC2). They are listed in Table
Table A-14. Fibre Channel Driver—Fatal Log Messages
ID | Log Message | No. |
|
|
|
102419 | #%d: qlutm_init: Diagnostic failed, port 1 invalid SRAM | 19 |
|
|
|
102420 | #%d: qlutm_init: Diagnostic failed, port 1 POST failed | 20 |
|
|
|
102421 | #%d: qlutm_init: Diagnostic failed, port 2 invalid SRAM | 21 |
|
|
|
102422 | #%d: qlutm_init: Diagnostic failed, port 2 POST failed | 22 |
|
|
|
102423 | #%d: qlutm_init: Failed to return diagnostic result to Bridge | 23 |
|
|
|
102656 | #%d: QLInitializeAdapter: Reset ISP failed | 256 |
|
|
|
102657 | #%d: QLInitializeAdapter: Load RISC code failed | 257 |
|
|
|
102658 | #%d: QLInitializeAdapter: Load ISP2322 receive sequencer code | 258 |
| failed |
|
|
|
|
102659 | #%d: QLInitializeAdapter: Load ISP2322 transmit sequencer | 259 |
| code failed |
|
|
|
|
102662 | #%d: QLInitializeAdapter: Verify Checksum command failed (%x) | 262 |
|
|
|
102680 | #%d: QLInitializeFW: FAILED | 280 |
|
|
|
102688 | #%d: QLInterruptServiceRoutine: Risc pause %x with parity error | 288 |
| hccr %x, Disable adapter |
|
|
|
|
102689 | #%d: QLInterruptServiceRoutine: Invalid interrupt status: %x | 289 |
|
|
|
10691 | #%d: QLFcipInterruptServiceRoutine: Risc pause %x with parity | 291 |
| error hccr %x, Disable adapter |
|
|
|
|
