A
4 – Command Reference Command Syntax
Set iSCSI
| Configures an iSCSI port. |
|
|
Authority | Admin session |
|
|
Syntax | set iscsi [port_num] |
|
|
Keywords | [port_num] |
|
|
| Specifies the number of the iSCSI port to be configured. |
| |
Examples Set iSCSI command example: |
|
| |
| QRouter (admin) #> set iscsi 1 |
|
|
| A list of attributes with formatting and current values will follow. | ||
| Enter a new value or simply press the ENTER key to accept the current | ||
| value. If you wish to terminate this process before reaching the end | ||
| of the list press 'q' or 'Q' and the ENTER key to do so. |
| |
| WARNING: |
|
|
| The following command might cause a loss of connections to both | ||
| ports. |
|
|
| Configuring iSCSI Port: 1 |
|
|
|
|
| |
| Port Status (0=Enable, 1=Disable) | [Enabled | ] |
| IP Address | [0.0.0.0 | ] |
| Subnet Mask | [0.0.0.0 | ] |
| Gateway IP Address | [0.0.0.0 | ] |
| Target TCP Port No. (Min=1024, Max=65535) | [3260 | ] |
| MTU Size (0=Normal, 1=Jumbo, 2=Other) | [Normal | ] |
| Window Size (0=8KB, 1=16KB, 2=32KB) | [32768 | ] |
| Window Scaling (0=Enable, 1=Disable) | [Enabled | ] |
| Window Scaling Factor (Min=0, Max=5) | [1 | ] |
| Port Speed (0=Auto, 1=100Mb, 2=1Gb) | [Auto | ] |
| Header Digests (0=Enable, 1=Disable) | [Enabled | ] |
| Data Digests (0=Enable, 1=Disable) | [Enabled | ] |
| VLAN (0=Enable, 1=Disable) | [Disabled | ] |
| IPv6 Address 1 | [:: | ] |
| 2001::1234 |
|
|
| IPv6 Address 2 | [:: | ] |
| IPv6 Default Router | [:: | ] |
