4 – Command Reference Command Syntax
S
Show iSCSI
Displays iSCSI information for the specified port. If you do not specify the port, this command displays both ports.
Authority | None |
|
Syntax | show iscsi [port_num] |
|
Keywords | [port_num] |
|
| Specifies the number of the iSCSI port to display. | |
Examples Show iSCSI port command example: | ||
| QRouter (admin) #> show iscsi |
|
| iSCSI Port Information |
|
|
| |
| iSCSI Port | 1 |
| Port Status | Enabled |
| Link Status | Up |
| iSCSI Base Name |
|
|
| |
| MAC Address |
|
| IP Address | 0.0.0.0 |
| Subnet Mask | 0.0.0.0 |
| Gateway IP Address | 0.0.0.0 |
| Firmware Revision No. | 3.00.02.44 |
| No. of Open Connections | 0 |
| Target TCP Port No. | 3260 |
| MTU Size | Normal |
| Window Size | 32768 |
| Window Scaling | Enabled |
| Window Scaling Factor | 1 |
| Current Port Speed | 1Gb/FDX |
| Programmed Port Speed | Auto |
| Header Digests | Enabled |
| Data Digests | Enabled |
| Max Burst | 262144 |
| Max First Burst | 65536 |
| VLAN | Disabled |
| IPv6 Address 1 | :: |
| IPv6 Address 2 | :: |