A
4 – Command Reference Command Syntax
Admin
| Opens and closes an administrator session. You can run any command that |
| changes the router configuration within an Admin session. Only one Admin |
| session can be open on the router at any time. An inactive Admin session will time |
| out after 15 minutes. |
| When you start an Admin session, the system prompts you to enter a password. |
| The default password is config. |
Authority | None |
Syntax | admin |
| start (or begin) |
| end (or stop) |
| cancel |
Keywords | start (or begin) |
| Opens the Admin session. |
| end (or stop) |
| Closes the Admin session. The logout, shutdown, and reset commands will |
| also end an Admin session. |
| cancel |
| Terminates an Admin session opened by another user. Use this keyword with |
| care, because it terminates the Admin session without warning the other user and |
| without saving pending changes. |
Notes | Closing a Telnet window during an Admin session does not release the session. In |
| this case, you must either wait for the Admin session to time out, or use the |
| admin cancel command. |
Examples | Opening and closing an Admin session example: |
| QRouter #> admin start |
| Password : ****** |
| QRouter(admin) #> |
| ... |
| QRouter(admin) #> admin end |
| QRouter #> |
