Q-Logic ISR6142 manual Command Usage, Logging On to a SAN Router

2 Command Usage

The command line interface (CLI) enables you to perform a variety of router management tasks through an Ethernet or serial port connection. This section describes the following:

„Logging On to a SAN Router

„Guest Account

„Working with SAN Router Configurations

Logging On to a SAN Router

To log on to a router using Telnet, open a command line window on the workstation and enter the Telnet command followed by the router IP address:

# telnet <ip_address>

A Telnet window opens prompting you for a login. Enter an account name and password.

To log on to a switch through the serial port, configure the workstation port with the following settings:

„115200 baud

„8-bit character

„1 stop bit

„No parity

Enter an account name and password when prompted.

SN0054659-00 A 2-1