A
4 – Command Reference Command Syntax
Set FC
| Configures a Fibre Channel port. |
Authority | Admin session |
Syntax | set fc [port_num] |
Keywords | [port_num] |
| Specifies the number of the FC port to be configured. |
Examples | Set FC command example: |
| QRouter (admin) #> set fc 1 |
| A list of attributes with formatting and current values will follow. |
| Enter a new value or simply press the ENTER key to accept the current |
| value. If you wish to terminate this process before reaching the end |
| of the list press 'q' or 'Q' and the ENTER key to do so. |
| WARNING: |
| The following command might cause a loss of connections to both ports. |
| Configuring FC Port: 1 |
| |
| Port Status (0=Enable, 1=Disable) [Enabled ] |
| Link Rate (0=Auto, 1=1Gb, 2=2Gb, 4=4Gb) [Auto ] |
| Frame Size (0=512B, 1=1024B, 2=2048B) [2048 ] |
| Execution Throttle (Min=16, Max=256) [64 ] |
| Programmed Connection Option: |
| (0=Loop Only, 1=P2P Only, 2=Loop Pref) [Loop Pref ] |
| All attribute values for Port 1 that have been changed will now be |
| saved. |
