|
|
|
| Chapter 2 Installation and Quick Start |
|
|
|
| Quick Start Guide |
|
|
| Use the following procedure to install desktop | |
| Desktop | |||
Drive. Print this page and check each step as you complete it. If you need | ||||
Drive Quick Start | more information about a step, turn to the section referenced in the step. | |||
|
|
| ||
| 1 | Unpack the contents of your drive package, and check for damaged items. | ||
|
|
| See Unpacking and Inspection. | |
|
|
| ||
| 2 | Review the drive’s default settings and change them if necessary: | ||
|
|
| • SCSI ID: 6 | |
|
|
| SeeSetting the SCSI ID on page 16. | |
|
|
| ||
| 3 | Connect a SCSI interface cable to the drive. | ||
|
|
| See Connecting a SCSI Cable on page 16. | |
|
|
| ||
| 4 | Check the SCSI termination. | ||
|
|
| See Checking the SCSI Termination on page 17. | |
|
|
| ||
| 5 | Connect a power cable to the drive. | ||
|
|
| See Connecting a Power Cord on page 17. | |
|
|
| ||
| 6 | • Turn on the computer | ||
|
|
| • Turn on the desktop tape drive | |
|
|
| • Verify that the desktop tape drive is operating properly. | |
|
|
| ||
| 7 | Register your tape drive. | ||
|
|
| See Registering Your Tape Drive on page 18. | |
|
|
|
|
|
5 |
