Chapter 2 Installation and Quick Start

Installing an Internal LTO-2 Half-Height Tape Drive

Connecting a SCSI The internal LTO-2 Half-Height Tape Drive has an Ultra3 SCSI interface,

Cableterminated by an LVD SCSI connector. Use the following procedure to connect a SCSI cable to this connector.

1Turn off all power to the drive and the computer.

2Attach the SCSI interface cable to the 68-pin SCSI interface connector on the back of the drive (see figure 5).

Figure 5 Rear View of

the Internal LTO-2

Half-Height Tape Drive

Library Interface Connector

SCSI Jumper Block

Pin 1

SCSI Connector

Power Connector

Caution: Install an LVD drive only in an LVD environment. Plugging an LVD drive into an HVD bus makes the entire bus non-functional and may permanently damage the drive or other SCSI devices on the bus.

LTO-2 Half-Height Tape Drive User’s Guide

13

Page 27
Image 27
Quantum manual Rear View Internal LTO-2 Half-Height Tape Drive