Chapter 2 Installation and Quick Start
Quick Start Guide
Quick Start Guide
|
|
|
|
| Use the following |
|
|
|
|
| running as quickly as possible. |
|
|
|
| Use the following procedure to install internal | |
| Internal |
| |||
|
| Drive. Print this page and check each step as you complete it. If you need | |||
Drive Quick Start | more information about a step, turn to the section referenced in the step. | ||||
|
|
| |||
| 1 | Unpack the contents of your drive package, and check for damaged items. | |||
|
|
| See Unpacking and Inspection. | ||
|
|
| |||
| 2 | Review the drive’s default settings and change them if necessary: | |||
|
|
| • | SCSI ID: 6 | |
|
|
| • | Terminator Power: Disabled | |
|
|
| See Configuring the Internal Tape Drive on page 7. | ||
|
|
| |||
| 3 | Turn off your computer, remove its covers and power cable, and select a mounting | |||
|
|
| bay for the drive. | ||
|
|
| See Mounting the Internal Tape Drive on page 11. | ||
|
|
| |||
| 4 | Connect a SCSI interface cable to the drive. | |||
|
|
| See Connecting a SCSI Cable on page 13. | ||
|
|
| |||
| 5 | Terminate the SCSI bus if the internal tape drive is the last device on the SCSI bus. | |||
|
|
| See Checking the SCSI Termination on page 14. | ||
|
|
| |||
| 6 | Connect a serial cable, if connecting the tape drive to a tape library. | |||
|
|
| See Connecting a Serial Cable for Tape Libraries on page 14. | ||
|
|
| |||
| 7 | Connect a power cable to the drive. | |||
|
|
| See Connecting a Power Cable on page 15. | ||
|
|
| |||
| 8 | Replace the computer covers and power cable, turn on the computer, and verify | |||
|
|
| that the internal tape drive is operating properly. | ||
|
|
| |||
| 9 | Register your tape drive. | |||
|
|
| See Registering Your Tape Drive on page 15. | ||
|
|
|
|
|
|
4 |
