Quantum manual Drive Performance Specifications, Specification LTO-2

		Chapter 5 Specifications
	Drive Performance Specifications
Specification		LTO-2
Max Continuous Operating Power (4)		25 watts RMS*
Max Peak Operating Power (5)		40 watts RMS (1 sec max)

Note: (1) No cartridge loaded (typical drive idle current/power)

(2)Cartridge loaded and tape-threaded -- drive ready for transfer (typical drive standby current/power)

(3)Average drive current/power measured during Read/Write mode at 4.53 m/s on a typical drive.

(4)Maximum drive current measured during Read/Write mode at 4.53 m/s. Worst case 1 second RMS measurement. Measured at the following worst case voltages (5.25V and 10.8V).

(5)Peak current/power, RMS current measured for maximum current do not occur at the same time max current condition. (1-5)RMS parameters measured at the power connector using a nominal voltages of 5.0V and 12.0V unless stated otherwise.

Drive Performance Specifications

Table 7 lists the performance specifications for the LTO-2 Half-Height

Tape Drive.

LTO-2 Half-Height Tape Drive User’s Guide 39