Quantum LTO-2 manual Jumpers, Open Shunted Default, Terminator Power

Chapter 2 Installation and Quick Start

Installing an Internal LTO-2 Half-Height Tape Drive

Table 1 SCSI IDs and Jumper Settings for LTO-2 Half-Height in Drive

	Jumpers
SCSI ID	1–2	3–4	5–6	7–8
0	Open	Open	Open	Open
1	Shunted	Open	Open	Open
2	Open	Shunted	Open	Open
3	Shunted	Shunted	Open	Open
4	Open	Open	Shunted	Open
5	Shunted	Open	Shunted	Open
6 (default)	Open	Shunted	Shunted	Open
7	Shunted	Shunted	Shunted	Open
8	Open	Open	Open	Shunted
9	Shunted	Open	Open	Shunted
10	Open	Shunted	Open	Shunted
11	Shunted	Shunted	Open	Shunted
12	Open	Open	Shunted	Shunted
13	Shunted	Open	Shunted	Shunted
14	Open	Shunted	Shunted	Shunted
15	Shunted	Shunted	Shunted	Shunted

Terminator Power

By default, terminator power is disabled on the internal LTO-2 Half-Height Tape Drive. To enable terminator power, place a jumper across pins 11 and 12.

Note: The internal LTO-2 Half-Height Tape Drive does not provide SCSI termination. Thus, a terminator must be installed on the drive if it is the last device in a SCSI chain.

10 LTO-2 Half-Height Tape Drive User’s Guide