Quatech MPAP-100 user manual Tying a configuration to a particular socket, Table of Contents

Table of Contents
1 Introduction	. 6
1.1 System Requirements	. 6
2 Hardware Installation	. 7
3 DOS / Windows 3.x Software Installation	. 8
3.1 MPAP-100 Client Driver for DOS	10
3.1.1 DOS client driver installation	10
3.1.2 Auto Fallback configuration	11
3.1.3 Hot Swapping	11
3.2 DOS Client Driver examples	13
3.3 MPAP-100 Enabler for DOS	14
3.3.1 DOS Enabler Installation	14
3.3.2 Hot Swapping is not supported	14
3.3.3 Configuring a card	14
3.3.4 Releasing a card's configuration	16
3.4 DOS Enabler Examples	17
4 Windows 95/98 Installation	18
4.3 Configuration Options	22
5 OS/2 Software Installation	23
5.1 System Requirements	23
5.2 OS/2 Client Driver Installation	23
5.2.1 Tying a configuration to a particular socket	24
5.2.2 Auto Fallback configuration	24
5.2.3 Hot Swapping	24
5.3 OS/2 Client Driver Configuration Examples	25
5.4 Monitoring The Status Of PCMCIA Cards	25
5.5 Installing OS/2 PCMCIA Support	26
6 Using the MPAP-100 with Syncdrive	27
7 Addressing	28
8 Interrupts	29
9 SCC General Information	30
9.1 Accessing the registers	31
9.2 Baud Rate Generator Programming	34
9.3 SCC Data Encoding Methods	34
9.4 Support for SCC Channel B	34
9.4.1 Receive data and clock signals	35
9.4.2 Extra clock support for channel A	35
9.4.3 Extra handshaking for channel A	35
9.4.4 Other signals are not used	35
9.5 SCC Incompatibility Warnings	36
9.5.1 Register Pointer Bits	36
9.5.2 Software Interrupt Acknowledge	36
10 FIFO Operation	37
10.1 Enabling and disabling the FIFOs	37
10.2 Accessing the FIFOs	37
10.2.1 Transmit FIFO	37
10.2.2 Receive FIFO	38
Quatech MPAP-100 User's Manual	iii