Proximal cuff Tube clipPressure sensor tube Luer connector
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Connect this end |
|
|
| Air |
| tubing |
|
|
|
|
|
|
|
| Connect this end | ||||||||||||||||||||||||||||
| |||||||||||||||||||||||||||||||||||||||||||
to the mask |
|
|
|
|
|
|
|
|
|
|
|
|
|
| to the flow generator | ||||||||||||||||||||||||||||
Figure 3: Air tubing fully assembled
All necessary air tubing components are packed with the AUTOSET CS2:
•a
•a pressure sensor tube (to measure pressure at the mask) with Luer connectors
•tube clips (to hold the pressure sensor tube onto the air tubing)
•a Proximal cuff (a special connector that attaches the pressure sensor tube into the main air tubing so that you only need to make one attachment to the mask).
The air tubing is supplied with the Proximal cuff connected. Attach the tube clips evenly along the air tubing. Press the pressure sensor tube into the tube clips, and screw the Luer connectors together at the Proximal cuff. Make sure the pressure sensor tube is not kinked, obstructed or twisted.
NOTE ResMed recommends the following tubing products for use with the AutoSet CS2: replacement air hose (only) PN 14948; replacement air delivery system (hose, sensor line, clips, proximal cuff) PN 26909.
MASKS
The following mask systems (supplied separately) are recommended for use with the AUTOSET CS2 system. Please refer to the table on page 26 to set up your mask correctly for use with the AUTOSET CS2.
ULTRA MIRAGE™ | MIRAGE™ FULL FACE | MIRAGE VISTA™ |
FULL FACE MASK | MASK SERIES 2 |
|
MIRAGE ACTIVA™ | ULTRA MIRAGE™ | PAPILLON |
Your clinician can explain the features of the masks available, and will discuss the mask that best suits your needs.
10
