ResMed AutoSet CS 2 user manual Reslink, Anti-Bacterial Filter

CAUTION

! • Be very careful not to allow water to enter the AUTOSET CS2 as this could affect therapy and/or damage the device.

• Do not tip the HUMIDAIRE while it is connected to the AUTOSET CS2. If water enters the AUTOSET CS2 device, turn off the main power switch at the back of the unit and unplug it from the power outlet. Return the unit to your equipment supplier for checking.

• Set up the HUMIDAIRE and the AUTOSET CS2 unit so that the tubing to the mask runs higher than the machines. This will prevent condensation build-up.

• If condensation appears in the mask, turn the humidifier settings down.

RESLINK™

The RESLINK™ is a device that records data onto a SmartMedia™ card during your therapy. The card can be returned to your clinician so that they can observe your progress and adjust flow generator parameters if necessary. The RESLINK connects to the back of AUTOSET CS2 as shown. For full details on using the RESLINK, please refer to the ResLink User’s Manual.

ANTI-BACTERIAL FILTER

Your clinician may recommend that you use an anti-bacterial filter. A filter should be placed in the air tubing between the mask and the flow generator. If using a humidifier, place the filter between it and the flow generator (see Figure 10 below).

Typically, the filter should be replaced daily. Check the filter instructions for full details.

Whenever a filter is added, removed or replaced you must run the Air Circuit Learn function (see “Learn Circuit” on page 26).

NOTE Only hydrophobic anti-bacterial filters should be used with a HUMIDAIRE 2i or HUMIDAIRE 2iC.

ENGLISH

THE AUTOSET CS2 SYSTEM

17