ResMed AutoSet CS 2 USING THE AUTOSET CS2, Starting Treatment, Stopping Treatment, Standby Mode

USING THE AUTOSET CS2

WARNING

! Before starting therapy with a new mask, select the correct mask type in the Settings menu (page 26). When adding or removing a new component such as a mask, humidifier or anti-bacterial filter, perform the Air Circuit Learn function (page 26).

STARTING TREATMENT

When the system is fully assembled, press the power switch at the back of the AUTOSET CS2 to ON. The Welcome screen will be displayed while the flow generator is warming up. Allow the unit to warm up for approximately 30 seconds before placing the mask on your face.

WELCOME

Figure 12: Welcome screen

Once the AUTOSET CS2 has warmed up, breathing into the mask should start therapy immediately. If not, press the Start/Stop key once to commence treatment.

The AUTOSET CS2 restarts in the mode in which it stopped.

ENGLISH

STOPPING TREATMENT

If SMARTSTOP is enabled, treatment will stop automatically when you remove your mask. If the SMARTSTOP function has been disabled, press the Start/Stop key.

STANDBY MODE

AUTOSET CS2 menu

Figure 13: Standby screen

Once you have stopped treatment, the AUTOSET CS2 will be in standby mode. In standby you can:

•press the power switch at the back to OFF to turn off the flow generator

•commence treatment again by breathing into the mask or pressing the Start/ Stop key

•enter any of the menus by pressing the Left key.

When in standby mode, a gentle (non-therapeutic) flow of air will still be present.

NOTE If the SMART DATA - AUTO APPEAR option is set to ON, the screens available under the Results menu will be displayed automatically for approximately 20 minutes after your session is completed.

USING THE AUTOSET CS2

21