Copier Functions

Specified Area Repeat

You can use this function only when you are making a copy from the Exposure Glass.

Note

H Enter the length of [Y1] with the number keys, then press [#].I Enter the length of [X2] with the number keys, then press [#].J Enter the length of [X2] with the

❒ The base point X1, Y1, and the

length set by point X2, Y2 deter-

mines the area of an image repeat-

number keys, then press [#].K Press [OK] three times.

2

edly copied.

Limitation

❒You cannot use the specified area repeat from ADF.

GCRE032E

1.Set on the exposure glass

A Specify the location of the area's base point (X1, Y1), and its length and width (X2, Y2).

Note

❒You can set any value in the range of X 1: 0~412 mm (0”~16.2”), X2: 20~432 mm (0.8”~17.0”), Y1: 0~277 mm (0”~10.8”), and Y2: 20~297 mm (0.8”~11.6”).

B Select the size of the copy paper and the reproduction ratio.

C Press [Edit / Colour Creation]. D Press [Edit Image].

E Press [Image Repeat].F Press [Specified Area].G Enter the length of [X1] with the number keys, then press [#].
L Place the original on the exposure glass, and then press the {Start}key.

Double Copies

One original image is copied twice onto one sheet, as shown.

Note

❒You cannot use the bypass tray with this function.

❒See the following table for original and copy paper sizes and orienta- tions when using a 100% ratio:

❖ Metric version

Original size and

Copy paper size

orientation

and orientation

 

 

A5L

A4K

 

 

B6 JISL

B5 JISK

 

 

A4K

A3L

 

 

A5K

A4L

 

 

B6 JISK

B5 JISL

 

 

63