Setting Originals
Setting the Original in the Auto Document Feeder (ADF)
Note
❒Do not set originals in the Auto Document Feeder (ADF) in excess of the upper limit mark. (Stacked height: Not more than 15mm (0.6"))
❒The number of sheets that can be set in the Auto Document Feeder (ADF) at one time depends on the size and weight (thickness) of the originals. Use the following table as a guide:
|
|
| Number of |
Stacked height | Weight | Size | sheets that can |
|
|
| be set |
|
| A4, A5, | 110 |
| 105g/m2 | (LT, HLT) | |
|
| ||
15mm | (24lb) | A3 | 80 |
| |||
(0.6") |
| (DLT) | |
|
| ||
|
|
|
|
| 64g/m2 | A4, A5, A3 | 150 |
| (20lb) | (LT, HLT, DLT) | |
|
| ||
|
|
|
|
Limitation
❒If there is a darkly colored image within about 40mm of the leading edge at the center of the original, the scanner may not be able to detect the presence of the original. In this case, either add a blank white sheet as the first page of the original, or place the original on the contact glass.
AAlign the originals on the ADF.
∙When scanning large originals, pull out the auxiliary table.
∙Adjust the stopper on the output table according to the size of the originals.
1:Auxiliary table
2:Stopper
21
