White Sheet, Contact Glass, ADF Cover, Rotary Switch | Ricoh IS450

1. Introduction

TH2H020E

1	3

2

4 5 6 78 9

1.White Sheet

This presses the document down on the contact glass.

2.Contact Glass

This is where the document is placed.

3.ADF Cover

Open this cover to clear paper jams, etc.

4.Power Connector

Connect the power cable here.

5.Rotary Switch

This switch is used to set the SCSI ID.

6.SCSI Connector

Connect the SCSI interface cable here.

7.Interface for Reverse Side Scan- ning

This is an extension interface for reverse side scanning. (Duplex Model only)

8.DIP Switches

These switches are used to set the operat- ing mode.

9.Reset Switch

This switch resets the scanner as if the power had been turned off and then back on again. This switch is used to make new DIP switch and rotary switch set- tings valid.

4

Image 18

Ricoh IS450 White Sheet, Contact Glass, ADF Cover, Power Connector, Rotary Switch, Scsi Connector, DIP Switches

Contents

Image Scanner Introduction Copyright Declaration of Conformity Safety Information Safety During OperationExamples of Indications Safety Information Iii Important Information Important Information Important Information Limitation How to Read This ManualHow to Read This Manual Reference Table of Contents Setting Originals OriginalsGeneral Scanning Method Manual Scanning DIP Switches Functions MaintenanceSpecifications OptionsPage Features Introduction Space-saving design Introduction Guide to the Scanner Scsi Connector Power ConnectorRotary Switch DIP Switches Understanding the Indicators Description Introduction Preparing for Installation Setup locationChecking the Scanner Location Setting up the Scanner Installation space Installation environment Important Usable range Recommended range Setting up the Scanner Connecting to the Host ComputerWhat is SCSI? Scsi Connection Require Ments for the Scanner Setting the Scsi ID Connecting the Scsi Cable No Connection to Other PortConnecting to the Host Computer Connecting the Scsi Cable Connection to Other Port Connecting the Power Cable Plug the other end of the power cable into the power outlet Turning On/Off the Scanner Power Turning On the Scanner PowerTurning Off the Scanner Power Initializing the Scanner Recommended Sizes and Weights of Originals Originals Difficult to Detect Sizes Original Sizes and Scanning Area Originals Original sizes that can be detected automaticallyContact glass Auto Document Feeder ADF Setting Originals Setting the Original on the Contact Glass Setting the Original in the Auto Document Feeder ADF Align the originals on the ADF Simplex scanning Duplex scanning Guides Make sure the Auto Document Feeder ADF is closed Setting Originals Scanning Originals General Scanning Method Manual Scanning Scanning Originals When Scanning Does not Start Item to check Action Error Indicators and Solutions TroubleshootingDescription of error Action Procedures to Correct Errors in the ADF When an Original is Jammed in the Auto Document Feeder ADF Replacing the Ink Ribbon Do not pull on the Endorser’s cord Cleaning the Endorser Maintenance Cleaning the Scanner Cleaning the Feed Roller and Drum Appendices Maintenance Cleaning the White Roller Duplex Model Only Maintenance Moving the Scanner Disposing of the Scanner Carrying the Scanner a Short Distance Options Image Processing Unit Type aRed Lamp Unit Type a Endorser Unit Type a Printing Function Specifications Scanner Electrical and Hardware Specifications DIP Switches Functions Preview Binary scanning ScanScanning Composition Halftone scanning Standard mode Dynamic threshold modeBinary Scanning/Threshold Halftone Scanning Gray Scale Scanning Area Extraction Section Area Multi-area Settings Auto Photo/Letter Resolution Brightness Contrast Gamma Correction Noise removal Binary FiltersParameter Download Smoothing Document Size Detection Document Size Detection on the Contact GlassDocument Size Detection in the Auto Document Feeder ADF When Erase Background is disabled When Erase Background is enabledErase Background DIP Switch 10, 27 Index Red Lamp Unit Appendices