6When you have finished, press OK.

7Repeat steps 5 and 6 to configure the other TCP/IP parameters: subnet mask and gateway address.

8Press the Scroll buttons until Static appears and press OK.

9Press the Scroll buttons until Primary DNS appears and press OK.

10Enter each byte of the address and press OK.

11Press the Scroll buttons until Secondary DNS appears and press OK.

12Enter each byte of the address and press OK.

13Press Stop/Clear to return to Standby mode.

Dynamic addressing (BOOTP/DHCP)

To have a TCP/IP address assigned automatically by the server, take the following steps:

1Press Menu until Network appears on the bottom line of the display.

2Press OK when TCP/IP appears.

3Press the Scroll buttons until DHCP or BOOTP appears and press OK.

4Press Stop/Clear to return to Standby mode.

Configuring EtherTalk

EtherTalk is AppleTalk used in an Ethernet network. This protocol is widely used in Macintosh network environments. To use EtherTalk, take the following steps:

1Press Menu until Network appears on the bottom line of the display and press OK.

2Press the Scroll buttons until EtherTalk appears and press OK.

3Press the Scroll buttons until On appears and press OK.

4Press Stop/Clear to return to Standby mode.

Setting Ethernet speed

You can select the communication speed for Ethernet connections.

1Press Menu until Network appears on the bottom line of the display and press OK.

2Press the Scroll buttons until Ethernet Speed appears and press OK.

3Press the Scroll buttons until the speed you want appears and press OK.

4Press Stop/Clear to return to Standby mode.

Restoring the network configuration

You can return the network configuration to its default settings.

1Press Menu until Network appears on the bottom line of the display and press OK.

2Press the Scroll buttons until Clear Setting appears and press OK.

3Press OK when Yes appears to restore the network configuration.

4Power the machine off and back on.

Printing a network configuration page

The Network Configuration page shows how the network interface card on your machine is configured.

1Press Menu until Network appears on the bottom line of the display and press OK.

2Press the Scroll buttons until Network Info. appears and press OK.

3Press OK when Yes appears.

The Network Configuration page prints out.

4.2 <Network setup>