Ricoh SP 3510DN Down. Doing so may cause a malfunction, One by one, By one as they are output

5. Paper and Other Media

Item	Description
Notes	• When loading OHP transparencies, take care not to load them upside
	down. Doing so may cause a malfunction.
	• It is recommended to place one sheet at a time.
	• Make sure to fan OHP transparencies every time before printing.
	Leaving OHP transparencies loaded in the bypass tray may cause
	them to stick together and result in a misfeed.
	• If multiple OHP transparencies are fed at the same time, load them
	one by one.
	• When printing on OHP transparencies, remove the transparencies one
	by one as they are output.
	• When printing on OHP transparencies that have a print side, load
	them with the print side over on the bypass tray. Not taking this
	precaution may cause them to stick to the fusing unit and cause
	misfeeds.
Envelope
Item	Description
Supported paper tray	Bypass tray
Duplex supported size	None

Notes

•The number of envelopes that can be printed in one minute is approximately half that of plain paper.

•Paper can be loaded only up to the lower of the two paper limit marks of the tray.

•If printed envelopes come out badly creased, load the envelopes in the opposite direction. Also, configure the printer driver to rotate the print object 180 degrees. For details about changing the loading orientation, see the printer driver Help.

•Environmental factors can degrade the print quality on both recommended and non-recommended envelopes.

•If envelopes are severely curled after printing, flatten them by bending them back against the curl.

•After printing, envelopes sometimes have creases along their long edges and toner smear on their unprinted sides. Their print images might also be blurred. When printing large, black-solid areas, striping can occur as a result of the envelopes overlapping.

•To correctly specify the length of an envelope whose flap opens along its short edge, be sure to include the open flap when measuring.

62