Roberts Gorden DAT75, DAT90, DAT100, DAT115 Fire Hazard, close to heater, injury or property damage

Attach this information to the wall near the ROBERTS GORDON® heater.

®

Read the installation, Commissioning, Operation and Service Manual thoroughly before installation, operation or service.

OPERATING INSTRUCTIONS WARNING

1.STOP! Read all safety instructions on this information sheet.

2.Open the manual gas valve in the heater supply line.

3.Turn on electric power to the heater.

4.Set the thermostat to desired setting (above ambient temperature).

The automatic starting sequence begins.

NOTE: Following long shutdown periods, the burner control may go to to 'LOCKOUT' during the start sequence. Push the reset button to recommence firing. Contact service department if 'LOCKOUT' continues (see manual for details).

TO TURN OFF THE HEATER

		Fire Hazard
1.	Turn the thermostat/time switch to 'OFF'. The burner will turn 'OFF'
immediately, but fans will continue to cool heat exchanger until the fan		Some objects can catch fire or explode when placed
thermostat switches off.
		close to heater.
IF THE HEATER WILL NOT OPERATE, TO ENSURE YOUR SAFETY,
FOLLOW THESE INSTRUCTIONS TO SHUT DOWN YOUR HEATER		Keep all flammable objects, liquids and vapors the
		required clearances to combustibles away from heater.
1.	Set the thermostat to off or the lowest setting.
2.	Turn off electric power to the heater.	Failure to follow these instructions can result in death,
3. Turn off the manual gas valve in the heater supply line.		injury or property damage.
4.	Call your registered installer/contractor qualified in the installation
	and service of gas-fired heating equipment.

Installation Clearances Roof Terminal

		Alternative
Air	Flue	Wall
Intake		Terminal
15 cm
		Air Flow
		Condense Drain
		Install to
		suitable drain
		60 cm
3 m
	Insulated
2.5 - 3.5 m*	Refrigerant pipes
	to cooling coil	Customers
	by Customer
		Suitable
		Condenser
		Unit

Clearances to Combustibles

	15 cm
50 cm	50 cm**
	30 cm

**80 cm is necessary to service heater.

Roberts-Gordon Europe Limited	Fax: +44 (0)121 506 7701	Roberts-Gordon, LLC	Telephone: 716.852.4400
Unit A, Kings Hill Business Park	Service Telephone: +44 (0)121 506 7709	1250 William Street
Darlaston Road, Wednesbury	Service Fax: +44 (0)121 506 7702	P.O. Box 44	Fax: 716.852.0854
West Midlands WS10 7SH UK	E-mail: uksales@rg-inc.com	Buffalo, NY 14240-0044 USA	Toll Free: 800.828.7450
Telephone: +44 (0)121 506 7700	E-mail: export@rg-inc.com

Installation Code and Annual Inspections: All installations and service of ROBERTS GORDON® equipment must be performed by a contractor qualified in the installation and service of equipment sold and supplied by Roberts-Gordon and conform to all requirements set forth in the ROBERTS GORDON® manuals and all applicable governmental authorities pertaining to the installation, service and operation of the equipment. To help facilitate optimum performance and safety, Roberts-Gordon recommends that a qualified contractor annually inspect your ROBERTS GORDON® equipment and perform service where necessary, using only replacement parts sold and supplied by Roberts-Gordon.

For installations at elevations above 2000' (610 m), the appliance shall be derated 4% for each 1000' (305 m) of elevation above sea level.

Further Information:Applications, engineering and detailed guidance on systems design, installation and equipment performance is available through ROBERTS GORDON® representatives. Please contact us for any further information you may require, including the Installation, Operation and Service Manual.

This products are not for residential use.

© 2007 Roberts-Gordon, LLC All rights reserved. No part of this work covered by the copyrights herein may be reproduced or copied in any form or by any means – graphic, electronic, or mechanical, including photocopying, recording, taping, or information storage and retrieval systems – without written permission of Roberts-Gordon.

www.rg-inc.com Printed in U.S.A P/N 91040089