Using the VS-1680 with a CD-R/CD-RW drive
5.Press [F3 (CDRRc)]. If [F3] does not indicate “CDRRc,” first press [PAGE] so that “CDRRc” appears, and then
press [F3 (CDRRc)].
6.Use [
][
][ 
][ 
] to move the cursor, and use the TIME/VALUE dial to set the parameters.
Source Song
Marked songs will be loaded. Move the cursor to a song that you wish to recover, and press [F4 (MARK)]. By pressing [F3 (ALL)] you can mark or unmark all songs at once. By pressing [F2 (SelSg)] you can view a list of the songs. At this time, mark the desired song, and press [F1 (Back)].
Erase All Songs <<ATTENTION>>
If this is “On,” the current drive will be initialized before the song data is recovered. If you wish to recover while preserving the songs that are saved on the current drive, set this “Off.”
CD Speed
Select the speed at which the song data will be recovered from disc.
x6 (1058 KBps): Recover at 6x speed (1058 kilobytes per second).
x2 (353 KBPs): Recover at double speed (353 kilobytes per second).
x1 (176 KBPs): Recover at normal speed (176 kilobytes per second). This will allow greater reliability.
NOTE
Depending on the disc, it may not be possible to recover reliably from some
“x2 (353 KBPs).” In this case, select “x1 (176 KBPs).” Even if the “CD Speed” is set to “x2 (353 KBps)” or
“x6 (1058 KBps)” the time it takes for recovery is not always 1/2 or 1/6 of the base. This is because writing to the internal hard disk can take a lot of time, or disc read errors can sometimes occur.
7.Press [F4 (Exec)]. A message will ask you for
confirmation.
8.Press [YES]. The display will ask “STORE Current?” (store the current song?).
9.If you wish to store the current song, press [YES]. If not, press [NO]. If a demo song is selected, press [NO].
10.The recovery operation will begin. If the data has been backed up to multiple discs, the disc will be ejected, and you will be prompted to “Insert Disc #” (# is the order number of each disk). Insert the next disc and press [YES].
11.When the
29
