Roland VS-1680 owner manual Specifying the speed of saving Speed, Backup procedure, Source Song

Using the VS-1680 with a CD-R/CD-RW drive

9.Press [F4 (Exec)].

10.Press [YES]. A message about the license agreement will appear. Read the message carefully, and if you consent to

that, press [YES]. The data will begin to write to the CD- R disc. If you do not consent, press [NO]. You will return to step 2.

fig.5-06

MEMO

The message about the license agreement is the same as “About the License Agreement” on the back cover of the “VS-1680 Owner’s Manual.”

11.When the data has been written successfully, the display will ask “Write Another ?” (write to another disc?). If you wish to write the identical song data to another CD-R disc, insert the new disc into the CD-RW drive, and press [YES]. If you press [NO], you will return to step 2.

Saving a song to a CD-RW disc (Backup)

Checking whether the song was saved correctly (+Verify)

After backing up a song to a CD-RW disc, you can now check whether or not the data was saved correctly (i.e., check the recorded state of the data).

If as a result of the +Verify operation, you are warned that the song data has not been saved correctly, you should back up to a different disc.

NOTE

When backing up to a CD-R, we recommend that you use +Verify to check whether the backup was performed correctly. However, +Verify checks the entire surface of the disc, so it takes a considerable amount of time.

Specifying the speed of saving (Speed)

When backing up a song on a CD-RW disc, you can now specify the speed at which the data will be written.

Backup procedure

1.As the current drive, select the drive (internal IDE hard disk) that contains the song you wish to back up.

2.Insert a CD-RW disc into the drive.

3.Press [PLAY (DISPLAY)].

4.Hold down [SHIFT] and [F6 (UTILITY)].

5.Press [F2 (CDRBk)]. If [F2] does not indicate “CDRBk,”

first press [PAGE] so that “CDRBk” is displayed, and then press [F2 (CDRBk)].

fig.5-07

6.Use [][][ ][ ] to move the cursor, and rotate the TIME/VALUE dial to set the parameters.

fig.5-08

Source Song

The marked songs will be backed up. Move the cursor to a song that you wish to back up, and press [F3 (MARK)]. By pressing [F2 (ALL)] you can mark or unmark all songs at once. By pressing [F1 (SelSg)] you can view a list of the songs. At this time, mark a song and press [F1 (Back)].

27