Frame Mapping Table Window, Frame Column | RTS ADAM specs

CHAPTER 3

Window Descriptions

Frame Mapping Table Window

The Frame Mapping Table window, shown in Figure 42, is used to link Tribus frames together. Determine the frame position (1 through 8) and enter the primary and secondary MCII-e Master Controller IP Addresses.

FIGURE 42. Frame Mapping Table

Frame Column

The Frame column displays the frame’s positional rank within the intercom system.

29

Image 33

RTS ADAM manual Frame Mapping Table Window, Frame Column

Contents

Adam See the enclosed warranty card for further details Contents Page Figures Page Version Requirements General Description Interface with Adam Features Specifications Configuration RequirementsBoard Performance Fail-Over Modes Full Redundancy Partial Redundancy Non-Redundancy Page Eight Frame Tribus System Non-Redundant Page Debug Information Uploading Debug Information Status window appears Navigate to C\Telex\AZedit\Debug To find the file you just created, do the followingPage Installation To install the Tribus into an Adam frame, do the followingRequirements Configuration Intercom Configuration window appears Select the The number of frames in the intercom radio button Click Intercom Sizing Wizard Select the Enable Test Audio recommended check box Intercom Configuration window reappears Click the browse button Click the Frame 2 IP Address 1 field Base 8 Port Number System Base 8 vs. Base 16 Port Number SystemsPage Base 16 Port Numbering System Example Base 16 Port Number System Force Autonomous Mode Check Box Connect To Frame Menu AZedit Connections Frame Column Frame Mapping Table Window MAC Address 1 Column IP Address 1 ColumnIP Address 2 Column MAC Address 2 Column Move Up Button Base 16 Column Check BoxMove Down Button Accept Frame Mapping Table from Other Frames Check Box Select Frame Window Test ButtonDone Button OK Button Cancel Button TBX Links Status Window TBX ColumnComm Column Partner Column Link Up/Dn Column Audio a Column Intercom AlarmsAudio B Column Audio C Column Intercom Alarms Window To open the Intercom Alarms window, do the following Alarm Time Column Resolved Time ColumnDescription Column Logging Window Configure Logging Window J9 Radio Button J1 Radio ButtonJ10 Radio Button Ethernet Radio Button Download Firmware to the TBX-Tribus Card Download Firmware Upgrades Click Begin Download Firmware Download window appears Successful Download Message Click OK Verify the Tribus card firmware has been updated