Manuals / RTS / Computer Equipment / Network Card

RTS ADAM manual Full Redundancy

Models: ADAM

1 48

Page 11

Full Redundancy

In Full Redundancy systems, there are two (2) links, shown in Figure 29, between each frame, so losing either one does not affect audio.

FIGURE 29. 4 Frame System with Full Redundancy, including failover Master Controller

Page 11

Image 11

Contents

ADAM TBX - TriBus Triple Bus Expander for ADAMSee the enclosed warranty card for further details INTRODUCTION of ContentsINSTALLATION AND CONFIGURATION DOWNLOAD FIRMWARE UPGRADESPage List of Figures Page CHAPTER IntroductionGeneral Description Version RequirementsFeatures Links Used SpecificationsConfiguration Requirements Board PerformanceFail-Over Modes Full Redundancy Partial Redundancy Non-Redundancy Page Figure 2 Eight Frame Tribus System - Non-Redundant Page Debug Information The Uploading Debug Information Status window appears 2. Navigate to C\Telex\AZedit\Debug The AZedit debug file is madeTo find the file you just created, do the following Page Requirements Installation and ConfigurationInstallation To install the Tribus into an ADAM frame, do the following1. Verify you are serially connected to AZedit ConfigurationConfigure each MCII-e Master Controller IP Address for the Ethernet To configure the IP Address for the MCII-e, do the followingThe Intercom Configuration window appears Configure the size of your Intercom system for each frameTo configure the size of your frame, do the following 6. Select the The number of frames in the intercom radio button 3. Click Intercom Sizing WizardThe Select Intercom Type window appears The Select Intercom Size window appearsThe Select Frame Links window appears 10. Select the Enable Test Audio recommended check boxThe Verify Intercom Configuration window appears 13. Click Finish The Intercom Configuration window reappears15. Click Test to verify the configuration validity 16. Click Apply to apply the configuration to the intercom system3. Click the browse button Configure the frame using the Frame Mapping window in AZedit2. Click the Frame 2 IP Address 1 field The field becomes active and a browse button appearsBase 8 Port Number System Base 8 vs. Base 16 Port Number Systemsinstalled Base 16 Port Number System The Intercom Configuration window appears Force Autonomous Mode Check BoxTo Force Autonomous Mode when no audio links are up, do the following The Intercom Configuration window closes AZedit ConnectionsCHAPTER Window DescriptionsFrame Mapping Table Window Frame ColumnMAC Address 2 Column IP Address 1 ColumnMAC Address 1 Column IP Address 2 ColumnAccept Frame Mapping Table from Other Frames Check Box Base 16 Column Check BoxMove Up Button Move Down ButtonIP Address 1 Column Select Frame WindowTest Button Done ButtonMAC Address 2 Column Cancel ButtonMAC Address 1 Column IP Address 2 ColumnExample TBX Links Status WindowTBX Column Comm ColumnB Partner Column A Link Up/Dn ColumnA Partner Column B Link Up/Dn ColumnAudio C Column Intercom AlarmsAudio A Column Audio B ColumnThe Intercom Alarms window appears To open the Intercom Alarms window, do the followingResolved Time Column Alarm Time ColumnHiding and Clearing Alarms Frame ColumnLogging Window Configure Logging WindowEthernet Radio Button J1 Radio ButtonJ9 Radio Button J10 Radio ButtonTo download firmware to the TBX-Tribus card, do the following Download Firmware UpgradesDownload Firmware to the TBX-Tribus Card CHAPTERThe download begins. This takes a minute or two to occur The Firmware Download window appearsThe Download Device Firmware window appears 7. Click Begin DownloadThe success message and Download Device Firmware window closes 11. Verify the Tribus card firmware has been updated